The receivers in green laser pointer products originally are not U disks

 Variances also exist in the receivers of  green laser pointer  products with U disks and without U disks.   The multi-stage perforation up to three, when the slab need to multi-level perforation, the first in the cutting process parameters (see parameter settings - process parameters) to select the high-pressure warm-up selection and low pressure preheat rewritten as a (is selected), In the tri mming parameters in high-pressure warm-up delay and low-pressure warm-up warm-up time delay setting. Perforation of the multi-level open preheat oxygen of normal warm-up, re-opened after a low-pressure warm-up delay low-voltage low-pressure warm-up switch (M18),
 Receivers with U disks in   green laser pointer  products can serve both as receivers and flash disks. and then open the high pressure preheat switch (M22) after high-pressure warm-up delay until the pre- The hot end. Extend the perforation method is that the torch to move the perforation to the nearest edge of the steel plate, press the [start] button to start the warm-up perforation after the perforation, the torch cast straight-line distance cut to the perforation point, and then continue cutting. Extension perforation using an extension of perforation in the cutting process will select Set as effective, so the perforation (M07) first prompted to move the torch in place to start, press.
    key to start preheating perforation. Before the automatic processing of preparations. Normal processing, the first torch at the location of the reference point, the location of the reference point is usually the basis of the progra mming. Excerpts processing, the torch at the starting position was chosen processing.  Receivers with U disks in   green laser pointer  products are usually set with memory chips. And the cutting nozzle and a high degree of control the cutting height, the system starts automatically after the torch from the cutting height to raise a (M70) height. Two. New program or the first processing program first automatic short run of the whole map or graphic zoom function ([F3]),
for the correctness of the check processing procedure at the same time determine the scope of the graphic display. Can also zoom function check processing details, free both formal processing. 3. Be selected: normal processing, breakpoint recovery, draw lines and other functions. 4. Check the processing speed is appropriate, through [+] [-] keys to adjust the speed ratio values. 5 Check the flame width is appropriate, {T} key to enter the correct slotted width ( mm), usually slotted width in CAD / CAM completed, simply by [T] key will cut slit width is set to 0 . 6. The receivers in  green laser pointer  products originally are not U disks.
If the file name of the first processing, or top of the screen display and the procedures for processing names are not the same, press [Enter] key, the system lists the current list of the existing program by moving the cursor to select the program to be processed, according to [Enter] to select it, press [G] key to display the current program trajectory; press [DEL] to delete the current program; press [ESC] to give up.  Automatic start of the machining program to start processing program is divided into: normal processing, breakpoint recovery processing, excerpts processing, drawing a line function.  Memory chips are fixed into the receivers of  green laser pointer  products.